Command manual

Command list

SET_GEOMETRY

Sets
*SET_GEOMETRY
"Optional title"
setid
gid${}_1$, ..., gid${}_8$
.
gid${}_{\mathrm{M}}$, ..., gid${}_{\mathrm{N}}$

Parameter definition

VariableDescription
setid Unique geometry set identification number
gid${}_1$, ..., gid${}_8$ Geometry identification number 1 to 8
gid${}_{\mathrm{M}}$, ..., gid${}_{\mathrm{N}}$ Geometry identification number M to N

Description

This command defines a set of geometries (see e.g. GEOMETRY_BOX).

Example

Pressure load on a surface defined with a geometry set

The commands below define a pressure load on square plate. Geometry 1 marks all faces on the top surface of the plate. Geometry 2 is a box. Referring to -2 means that all faces inside the box are removed from the face list. Geometry 3 adds faces inside a cylinder and, finally, Geometry 4 removes faces inside a box.

*LOAD_PRESSURE
GS, 123, 234
*SET_GEOMETRY
123
1, -2, 3, -4
*GEOMETRY_SEED_COORDINATE
1
0.5, 0.5, 0.01
*GEOMETRY_BOX
2
0.1, 0.1, 0, 0.9, 0.9, 0
*GEOMETRY_PIPE
3
0.5, 0.5, 0.0099, 0.5, 0.5, 0.0101, 0.3
*GEOMETRY_BOX
4
0.4, 0.4, 0, 0.6, 0.6, 0
*FUNCTION
234
1.0e5
Pressure load on a square plate
Pressure load on a square plate